Pickups for other instruments:  Cello

AMT Cello Microphone Systems (S18C) - Wired and Wireless

Manufactured by: AMT

AMT S18C Cello Microphone
AUTHORIZED DEALER - AMT suggests you purchase their products only from authorized sources
The mic the pros choose...

The S18C is an electret-condenser microphone specifically designed to reproduce cello. All of the parameters that can be problematic for string instruments have been addressed. In order to get the most gain before feedback, it uses a very tight pattern, for a high rejection of surrounding noise, while at the same time reproducing accurately the subtleties of the instrument. As placement is especially important with an instrument that has a fine finish and varying dimensions, this microphone's attachment mechanism is designed to secure the mic to the cello in different positions taking seconds to attach. This mechanism is fitted with natural soft suede so as not to mark or mar your valuable instrument.

Made from aluminum to keep the mass low yet extremely strong, this microphone will remain durable through many years of use. The flex arm is easy to position yet retains it's placement throughout the most active of performances. The mic has an LED that can be easily seen while performing. This indicates status of a battery or phantom power.

The pre-amp for the microphone is a rugged anodized aviation aluminum housing that encloses the electronics, allowing it to be placed on the floor. This pre-amp utilizes a circuit that can allow for the option to change EQ, curve, and gain by exchanging an EPROM-like chip (contact AMT for details). The pre-amp runs off 9 volt battery or phantom power. The output is terminated with a male XLR type connector for balanced use, and includes a ground lift switch, if needed, to avoid the hum potential. The mic is connected to the pre-amp by a four pin locking connector.

Wireless? Add the Wi5C Wireless system to this mic, and have the flexibility to go wireless or wired, depending on the situation! The Wi5C Wireless System is specially designed to work exclusively with AMT Clamp-on Microphones which incorporate the disconnecting mic cable. It replaces the small preamp box -- the wireless transmitter provides the phantom power to the microphone, and the receiver box provides the output to the amplifier or mixing board. The system is "frequency-agile," meaning that you can tune the transmitter and receiver to one of 16 different channels to ensure that you can use it at the same time as other musicians using wireless systems; it also gives you the ability to "change the channel" if you're receiving interference on a particular channel. More information about the Wi5C can be found on the Wi5C page, which is linked below in the "Related Items" section.

Specifications:

• Element: Condenser
• Polar Pattern: Cardoid
• Frequency Response: 40Hz - 18kHz
• Sensitivity: -63dB+ 4dB
• Impedance: 150 Ohms*
• Phantom Power: 12 to 52 vDC*
• Self-powered, 9v battery
• Max input: SPL 124 dB
• Dimension: 7" Flex Arm
• Mechanism Dimensions: Opens min. 31/2" to max. 8"
• Cable: 10'
• Weight, Mic only: 58 grams

The system includes the AMT S18C Microphone, AP40 Floor Preamp with XLR output, and the hardshell Blo-mold protective case. A word about custom AMT mic mounting arrangements: You may have seen unique microphone mounting arrangements on some basses, most recently endpin mounts. These are the result of custom work, and are not available at point of purchase through any dealer. Applied Microphone Technology, Inc. asks that you purchase and perform with the unit prior to considering any custom work. After purchase and use you may contact AMT directly to inquire about custom alternate mounting solutions available directly from the manufacturer.

H-Clamp Light Upright Bass and Cello Microphone Mount

The H-Clamp is a very sophisticated adjustable instrument microphone mount, with models for Upright Bass, Cello, and Guitar. It places your favorite mic exactly where you want, for use both live and in the studio...

Ehrlund Acoustic Pickup (EAP) Linear Microphone w/Preamp (for acoustic instruments)

The EAP (Ehrlund Acoustic Pickup) is a specially designed "linear microphone" which attaches to your bass top with a special non-permanent putty, and produces a realistic, mic-like sound with the ease of use of a pickup...

David Gage Realist SoundClip Cello Pickup

The NEW David Gage Realist SoundClip can help bring your sound to your cello, with no modifications to your instrument, and instant on-off convenience. The unique transportability and high quality, variable sound makes it an excellent pickup option...

AMT Wi5C Wireless Add-On System for AMT Microphones

Add the freedom of WIRELESS to your AMT Bass, Cello, or Violin microphone! 16 channel selectable, designed specifically for the AMT mics...

Realist CELLO Pickup

The David Gage Realist pickup rapidly became a very popular choice of bass pickup, and we also have the Cello and Viola/Violin versions...